Equipment

Range of masses, to an a.a.
– in the linear mode – 20-260000
– in the reflective mode – 20-20000
Limit of an admissible relative error of measurement of weight, ppm
– in the linear mode – 50-100
– in the reflective mode – 10-50
Permission on a half-height
– in the linear mode – 5-103 for masses to less than 3-103 a.a., 103 for masses to more than 104 a.a.
– in the reflective mode – 2,5-104 for masses to less than 3-103 a.a., 103 for masses to more than 104 a.a.
Detection limit at summation of 50 laser impulses for 1 фмоля at m/z = 2465,2 (ACTH 18-39 peptide), the relation signal/noise – 10
Stability of a scale of masses:
deviation within 0,5 hours δm/m, ppm – ±25

Monochromator Dual polarising, dual dispersing monochromator
Light Source 150W air-cooled Xe arc lamp
Wavelength range <170nm to 900nm; extended to 1250nm with optional IR detector
Cell carriage Single cell, Peltier temperature controlled
Optional 4-cell auto changer also available Detection modes (5 channels) Simultaneous CD, absorbance, temperature, detector HT and DC voltage
Typical RMS noise specifications (measured at 1nm Bandwidth and 2 sec D.I.T.)
0.07mdeg @ 175nm 0.03mdeg @ 180nm 0.03mdeg @ 200nm 0.03mdeg @ 250nm 0.04mdeg @ 500nm
Stray light <3ppm at 200nm
Wavelength resolution 0.1nm at all wavelengths
Nitrogen purge requirements 5 l/min across the entire wavelength range; 2 l/min in the near UV (> 200nm)
Bench space, W x H x D 150 x 55 x 60cm

Permission: ≤ 0.24 nanometer
Photometric accuracy: +/-0.001 And
Photometric range: 0.001-5 And
Spectral range: 190–900 nanometers
Wavelength accuracy: ± 0.2 nanometers
Peltye thermosystem: 5-90 °C

150 watt. Without ozon-xenon lamp
Monochromator excitation:  250 – 850 nm
Monochromator radiation: 250 – 850 nm
Correction of spectral sensitivity: 300 – 800 nm
The spectral slit width: 0.1 – 30 nm
Length accuracy won: +/- 0.5 nm
Relationship signal/noise: 3000
Storing the data in the format of Origin

High-speed centrifuge Allegra 64R:

Rotation speed – 0 to 30000 rpm;

Maximal relative acceleration – 64400g;
Maximal capacity – 4×85 mL;
Tubes capacity – from 1.5 to 50 mL;
Temperature setting – from −20 to +40°C;
Ten acceleration / deceleration modes

Microplate reader Multiskan EX:
Spectral range – 400-750 nm.
Measurement range – 0-2.5 OD at 405 nm.
Accuracy – ±1% (0-2.0 OD).
Repeatability – <0,2% (0-2.0 OD).
Linearity – ±1,5% (0-2.0 OD).
Measurement speed – 5 seconds per 96-well microplate.

The BIOSTAT® B plus fermentation system:
– Volume 2 L
– Digital Controller
– Graphical user interface with color display and touch screen operation
– Integrated amplifiers for Temperature, pH, DO, combined Foam | Level amplifier
– Space for Redox and Turbidity amplifier(single only)
Application driven integrated gassing system, choice of: microbial culture, O2 Enrichment, Gas Flow Ratio Control, cell culture | dual use, Exclusive Flow, cell culture, Additive Low Flow
– Agitation System: Speed range 20 up to 2,000 rpm, Maintenance free, Gear-free for quite operation

The laboratory fermentations system for the microbiological synthesis of biologically active substances:
Interchangeable culture vessels 2/5 l

Equipment for real-time PCR Biorad:
Delivers accurate quantification for up to five targets within large volume reactions.
Max. ramp rate, 5°C / per second
Temperature Range, 0-100°C
Temperature Accuracy, ±0.2 of programmed target at 90°C
Range of Excitation / Emission Wavelengths – 450 – 730 nm

Refrigerated Centrifuge Avanti:
Maximum Speed – 20,000 RPM
Maximum RCF (g Force) – 51,500 x g
Temperature Range – 10° to 40°C
Temperature Accuracy – ± 2° of set temperature
Rotor JLA-8.1000 capacity – up to 6L

BioRad MicroPulser Electroporator:
– optimized programs for commonly studied bacteria and fungi allow rapid program selection
– Output voltage and pulse duration adjustment
– Voltage adjustable in 200–3,000 V range with 10 V precision; 5 ms default or 1–4 ms with 0.1 ms precision.

Microbiological control point in the complex:
Incubator Shakers: Innova® 40R
– 15°C below ambient to 80°C, min. 4°C.
– Accurate and Uniform Temperature Control:± 0.1°C with uniformity of ± 0.25°C at 37°C.
– Agitation: 25 – 500 rpm, ± 1 rpm.
Thermo Holten Laminar Air –  Class II Biological Safety (Safe 2020/0.9)
HEPA filter efficiency – 99,995%
Int dims (H x W x D), (mm) – 725/650 x 900 x 580

Gel Documentation System Shap id:
UV Transilluminator TFP-20C/WL (254 nm/ visible light)

Laboratory Autoclave Sanyo LaboautoclaveMLS-2420L:
Sterilisation temperature          – 105 ~ 126 °C
Effective capacity –  20 litres
Pressure gauge range –           0 – 0.3 Mpa / 0 -45 psi

3-liter fermenters:
The number of fermenters — 8. The working volume of 0.5-2.0 l Measured parameters: pH, pO2, stirrer speed, temperature, foaming. The cultivation modes: periodic, oxistat,  chemostat. Control: a local controller maintaining the set values of pH, pO2, temperature, rpm of the agitator; the computer registration of all parameters of cultivation. It is possible to grow the bacteria, yeasts, fungi. The number of channels for medium feeding – three.

Sterilizable fermenter 50-liter:
The working volume of 30 to 60 liters. Measured parameters: pH, pO2, stirrer speed, temperature, foaming. Control: a local controller with registration of all parameters of cultivation. It is possible to grow the bacteria, yeasts, fungi. The number of channels for medium feeding – three.

10-liter fermenter:
The number of fermenters is 2. The working volume of 4,0-8,0 L. Measured parameters: pH, pO2, stirrer speed, temperature, foaming. The cultivation modes: periodic, oxistat, hemostat. Control: a local controller maintaining the set values of pH, pO2, temperature, rpm of the agitator; the computer registration of all parameters of cultivation. It is possible to grow the bacteria, yeasts, fungi. The number of channels for feeding – three.

The number of fermenters — 8. The working volume of 0.4 — 1.0 liters Measured parameters: pH, pO2, stirrer speed, temperature, foaming. The cultivation modes: periodic, oxistat, hemostat. Control: a local controller maintaining the set values of pH, pO2, temperature, rpm of the agitator; the computer registration of all parameters of cultivation. It is possible to grow the bacteria, yeasts, fungi. The number of channels for feeding – three.

Maximum speed — 20 000 rpm (51 500g). The capacity of the rotor JLA-8.1000 up to 6 liters, temperature range: -10 : +40ºC

The working volume of 85 L. Temperature regimes and time of sterilization are set by the user. Temperature range – from 100 to 134 ^oС

Drying is designed for drying samples from the frozen state at low pressure (20-30 microtorr). Capacity by the ice up to the 3 liters. Capacity by water up to 2 liters/day.

Evaporative capacity by water 1 l/h. Air flow up to 35 m3/h Max inlet temperature 220 ºC. Range of particle diameters 1-25 microns